Command and Conquer: Renegade Official Forums: Mod Forum » C&C_CTFCY

Home » Renegade Discussions » Mod Forum » C&C_CTFCY - Released

Show: Today's Messages :: Polls :: Message Navigator

C&C_CTFCY - Released [message #10163]

Fri, 28 March 2003 10:33

Deafwasp
Messages: 555
Registered: February 2003

Karma:

Colonel

Um, its not hard at all to allign any building. You just count the number of sides the building has, then make a plane with so many verticies and cut a hole in it with enough sides to match the building. Then you line up the sides to the building by copping and pasting the verticies XYZ coordinates. Wont take but a few minutes.

That is the way I know to do that. And I guess if your not that good of a modeler it is difficult :rolleyes:

Again, about new doors and things of that nature, I guess you need to have some modeling skills......

A concrete wall? Well that was one suggestion. And that isnt a big stretch of the imagination.

Report message to a moderator

[Message index]

		C&C_CTFCY - Released By: Beanyhead on Tue, 25 March 2003 19:27
		C&C_CTFCY - Released By: Deafwasp on Thu, 27 March 2003 16:01
		C&C_CTFCY - Released By: Havocman on Thu, 27 March 2003 16:06
		C&C_CTFCY - Released By: Hellweed on Thu, 27 March 2003 16:24
		C&C_CTFCY - Released By: General Havoc on Thu, 27 March 2003 17:13
		C&C_CTFCY - Released By: bigwig992 on Thu, 27 March 2003 17:20
		C&C_CTFCY - Released By: Beanyhead on Thu, 27 March 2003 19:47
		C&C_CTFCY - Released By: Deafwasp on Thu, 27 March 2003 20:33
		C&C_CTFCY - Released By: bigwig992 on Thu, 27 March 2003 20:46
		C&C_CTFCY - Released By: Beanyhead on Fri, 28 March 2003 09:32
		C&C_CTFCY - Released By: Deafwasp on Fri, 28 March 2003 10:33
		C&C_CTFCY - Released By: Beanyhead on Fri, 28 March 2003 10:53
		C&C_CTFCY - Released By: Rich[HN] on Fri, 28 March 2003 10:57
		C&C_CTFCY - Released By: Deafwasp on Fri, 28 March 2003 12:17

Previous Topic:	Aircraftkiller: Lightscape?
Next Topic:	can't export with 1 alpha mesh and 1 non

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Jun 05 04:47:54 MST 2026

Total time taken to generate the page: 0.00826 seconds