Command and Conquer: Renegade Official Forums: Mod Forum

Home » Renegade Discussions » Mod Forum » Eddital mesh in renx

Show: Today's Messages :: Polls :: Message Navigator

Eddital mesh in renx [message #163377]

Fri, 15 July 2005 16:35

Fleetatks
Messages: 58
Registered: April 2005

Karma: 0

Recruit

how do u make it so theres more then just 16 dots on ur mesh thing? Big Ups

Report message to a moderator

Re: Eddital mesh in renx [message #163379 is a reply to message #163377]

Fri, 15 July 2005 16:40

danpaul88
Messages: 5795
Registered: June 2004
Location: England

Karma: 0

General (5 Stars)

by dots I assume you mean verticies?

To make more dots you have to change the Length and Widths segs values before converting to mesh.

http://steamsignature.com/card/1/76561197975867233.png

Report message to a moderator

Re: Eddital mesh in renx [message #163380 is a reply to message #163377]

Fri, 15 July 2005 16:45

Fleetatks
Messages: 58
Registered: April 2005

Karma: 0

Recruit

and how do u do that and what does it mean lol? Big Grin

Report message to a moderator

Re: Eddital mesh in renx [message #163381 is a reply to message #163377]

Fri, 15 July 2005 16:48

danpaul88
Messages: 5795
Registered: June 2004
Location: England

Karma: 0

General (5 Stars)

uhm, when you create the plane (using a plane as an example) the default settings are 3 Length and 3 Width Segments. This means the plane is 3 polygons wide and 3 polygons long.

If when you first make your plane you increase the value of the Length or Width it chops the plane into smaller segments, creating more polygons and therefore more dots.

For example 5 Wide and 5 Long will give 25 dots.

Hope this helps, its hard to explain simply....

Report message to a moderator