Command and Conquer: Renegade Official Forums: Mod Forum

Home » Renegade Discussions » Mod Forum » Extraction from always.dat

Show: Today's Messages :: Polls :: Message Navigator

Re: Extraction from always.dat [message #404206 is a reply to message #404172]

Sun, 27 September 2009 23:36

Spyder
Messages: 1070
Registered: March 2006

Karma:

General (1 Star)

Saberhawk wrote on Mon, 28 September 2009 04:45

raven wrote on Sun, 27 September 2009 21:22

Ah.. I've been using XCC mixer lol

I'll give that a try, thanks Smile

Mixer has 3 columns. Pull out the middle one and navigate to where you want the files extracted to. Then navigate to always.dat or whatever and select all the files and then choose "Copy" and it'll extract them all into where you have the middle column located.

True, but one small note. It might look like XCC Mixer stops working, but if you wait a short while it will start responding again, and you'll see that all files have been copied.

Report message to a moderator

[Message index]

		Extraction from always.dat By: raven on Sun, 27 September 2009 17:54
		Re: Extraction from always.dat By: Altzan on Sun, 27 September 2009 18:04
		Re: Extraction from always.dat By: raven on Sun, 27 September 2009 18:22
		Re: Extraction from always.dat By: saberhawk on Sun, 27 September 2009 19:45
		Re: Extraction from always.dat By: Spyder on Sun, 27 September 2009 23:36
		Re: Extraction from always.dat By: ErroR on Mon, 28 September 2009 05:08
		Re: Extraction from always.dat By: Altzan on Mon, 28 September 2009 05:44

Previous Topic:	Calling all avid skinners/modders.
Next Topic:	My Custom Bloom

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Jul 25 22:17:35 MST 2025

Total time taken to generate the page: 0.00799 seconds