Command and Conquer: Renegade Official Forums: Mod Forum

Home » Renegade Discussions » Mod Forum » VIS question

Show: Today's Messages :: Polls :: Message Navigator

VIS question [message #-987708]

Fri, 03 January 2003 11:00

Anonymous

If I run the auto VIS once, can I run it again to "add" data points inside objects that were added later?

What I did was the following:

Had base terrain and ran auto VIS without buildings (because they were causing problems), and then I added them. But now when the character respawns from traveling a ways from base, the character is invisible until they run outside.

Any help would be greatly appreciated.

Report message to a moderator

[Message index]

		VIS question By: Anonymous on Fri, 03 January 2003 11:00
		VIS question By: Anonymous on Fri, 03 January 2003 11:02
		VIS question By: Anonymous on Fri, 03 January 2003 11:23

Previous Topic:	Changing the axis of rotation in gmax/renx
Next Topic:	E3 replica Hand of Nod released.

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Jan 17 12:02:50 MST 2026

Total time taken to generate the page: 0.00651 seconds