Command and Conquer: Renegade Official Forums: Other

Home » Technical Support » Other » i have run into a problem...

Show: Today's Messages :: Polls :: Message Navigator

Re: i have run into a problem... [message #213344 is a reply to message #213132]

Tue, 15 August 2006 06:49

jnz
Messages: 3396
Registered: July 2006
Location: 30th century

Karma:

General (3 Stars)

the code doesn't say "while(l)" it says "while(1);" since it is a new thread it doesn't matter if it goes into a infinit loop because it wont halt the program. it goes into an infinite loop to recive data on port 3002.

after alot of debuggung, i have fixed it. it turns out that LoadScopes() function must be called 2 times because i put my function call just after that. when it got called the 2nd time it tryed to open port 3002 which is already open and it crashes.

Report message to a moderator

[Message index]

		i have run into a problem... By: jnz on Mon, 14 August 2006 02:47
		Re: i have run into a problem... By: light on Mon, 14 August 2006 03:01
		Re: i have run into a problem... By: jnz on Mon, 14 August 2006 04:07
		Re: i have run into a problem... By: light on Mon, 14 August 2006 16:43
		Re: i have run into a problem... By: danpaul88 on Mon, 14 August 2006 16:46
		Re: i have run into a problem... By: jnz on Tue, 15 August 2006 06:49

Previous Topic:	just a quick question...
Next Topic:	vid card

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Tue Feb 03 11:53:47 MST 2026

Total time taken to generate the page: 0.00700 seconds