Command and Conquer: Renegade Official Forums: Mod Forum » CLOSED well not closed butdont need no more help on this

Home » Renegade Discussions » Mod Forum » CLOSED well not closed butdont need no more help on this

Show: Today's Messages :: Polls :: Message Navigator

Re: How Do I Cut 42 Boxe's Out In Gmax To Make A Tower [message #308082 is a reply to message #307482]

Sat, 05 January 2008 18:19

cpjok
Messages: 425
Registered: September 2007

Karma:

Commander

ok i got it to cut all holes out and that and i added ladders and when i export it. it takes ages then when i try open it in 3WD Viewer it has internal ERROR

how do i get it to atually work

Report message to a moderator

[Message index]

		CLOSED well not closed butdont need no more help on this By: cpjok on Wed, 02 January 2008 20:28
		Re: How Do I Cut 42 Boxe's Out In Gmax To Make A Tower By: cpjok on Wed, 02 January 2008 20:42
		Re: How Do I Cut 42 Boxe's Out In Gmax To Make A Tower By: Jerad2142 on Thu, 03 January 2008 01:26
		Re: How Do I Cut 42 Boxe's Out In Gmax To Make A Tower By: Dealman on Thu, 03 January 2008 13:05
		Re: How Do I Cut 42 Boxe's Out In Gmax To Make A Tower By: R315r4z0r on Thu, 03 January 2008 13:35
		Re: How Do I Cut 42 Boxe's Out In Gmax To Make A Tower By: fatalcry on Thu, 03 January 2008 01:27
		Re: How Do I Cut 42 Boxe's Out In Gmax To Make A Tower By: crazfulla on Thu, 03 January 2008 10:12
		Re: How Do I Cut 42 Boxe's Out In Gmax To Make A Tower By: cpjok on Thu, 03 January 2008 21:29
		Re: How Do I Cut 42 Boxe's Out In Gmax To Make A Tower By: R315r4z0r on Thu, 03 January 2008 21:42
		Re: How Do I Cut 42 Boxe's Out In Gmax To Make A Tower By: cpjok on Sat, 05 January 2008 16:55
		Re: How Do I Cut 42 Boxe's Out In Gmax To Make A Tower By: cpjok on Sat, 05 January 2008 18:19

Previous Topic:	Animation names
Next Topic:	Just wondering if you guys now if this is possible

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Feb 08 14:21:15 MST 2026

Total time taken to generate the page: 0.00759 seconds