Command and Conquer: Renegade Official Forums: Mod Forum

Home » Renegade Discussions » Mod Forum » lod on emitters

Show: Today's Messages :: Polls :: Message Navigator

Re: lod on emitters [message #489090 is a reply to message #489089]

Wed, 20 August 2014 06:55

Jerad2142
Messages: 3828
Registered: July 2006
Location: USA

Karma:

General (3 Stars)

danpaul88 wrote on Wed, 20 August 2014 07:20

Particle_Detail in the registry. Value range 0 - 2

I'm not sure it actually does anything though, the value gets read but then seems to go out of scope without being used. From what I can see the LoD system for particles basically caps the maximum size of particles smaller and smaller as the LoD decreases... whether it renders bigger ones smaller or just flat out erases particles larger than the current cap I'm not sure.

I suspect the particle LoD is dictated by the dynamic LoD budget, which is set via the registry.

The above is just what I can see from a quick scan through the code, it might or might not be accurate, saberhawk or jonwil would know more about it.

Nah I saw that too, that's just for the slider position (3 spots, low med high).

Bet your right, I bet I just bumped the dynamic LOD budget way up (Or set it so when you move the slider in game the high value pushes it much higher).

Visit Jerad's deer sweat shop

Report message to a moderator

[Message index]

		lod on emitters By: roszek on Tue, 19 August 2014 13:02
		Re: lod on emitters By: Jerad2142 on Tue, 19 August 2014 16:17
		Re: lod on emitters By: roszek on Tue, 19 August 2014 21:11
		Re: lod on emitters By: Jerad2142 on Wed, 20 August 2014 05:49
		Re: lod on emitters By: danpaul88 on Wed, 20 August 2014 06:20
		Re: lod on emitters By: Jerad2142 on Wed, 20 August 2014 06:55
		Re: lod on emitters By: roszek on Wed, 20 August 2014 13:33
		Re: lod on emitters By: saberhawk on Thu, 21 August 2014 10:38
		Re: lod on emitters By: roszek on Thu, 21 August 2014 20:39
		Re: lod on emitters By: roszek on Tue, 09 September 2014 11:22
		Re: lod on emitters By: Jerad2142 on Wed, 10 September 2014 12:48
		Re: lod on emitters By: roszek on Thu, 11 September 2014 10:12
		Re: lod on emitters By: dblaney1 on Thu, 11 September 2014 13:58

Previous Topic:	First person view gun animation
Next Topic:	Nod 15 Inch Coastal Defense Gun

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri May 29 19:41:03 MST 2026

Total time taken to generate the page: 0.00862 seconds